What is needed for the cooperation between the mold and the component?

What is needed for the cooperation between the mold and the component? That's right, it's the guide post, and that's what the editor brings to you today. The guide post can ensure that the mold can move accurately and guide the mold. It is usually cylindrical with shoulders, and the oil grooves will increase with the length of the guide post, up to 8. There are many types of guide posts. According to the guiding direction, they are divided into sliding guide posts and rolling guide posts; according to the installation form, they are divided into loading and unloading guide posts and press-in guide posts; Column, formwork guide column, stripper guide column, etc.

Precautions for guide post assembly 1. Clean the mounting holes and check whether the bolts and guide posts are fixed. 2. Determine the verticality of the guide column. 3. Use a hydraulic press or other methods to slowly press in. (Note: You cannot use a hammer to knock in, otherwise it will deform)
Precautions for installation and removal of guide post 1. Remove the movable stopper, steel ball bushing and spring on the guide post, and remove the loading and unloading gasket 2. Make sure that the inner surface of the mounting hole and the threaded hole are not damaged, so use copper alloy Make the backing plate 3. Put the parallel block on the upper die seat first, and then put it on the lower die seat but do not touch the needle roller guide post and the steel ball guide post 4. We must ensure that there is no interference between the guide post and the mounting hole, It is necessary to roll all the guide posts, and if so, change the position of the upper die seat.